Industry Information

Update December 05, 2022

Reasons why cemented carbide moulds are widely used for battery sealing

Carbide moulds are widely used for battery sealing due to several reasons. Firstly, carbide is known for its high strength and durability, making it an ideal material for moulds that need to...

Update December 02, 2022

How are tungsten carbide rolls produced?

How are tungsten carbide rolls produced? Roll made from tungsten carbide and cobalt etc. by powder metallurgy, it was born in 1909 after the introduction of powder metallurgy technology and with the...

Update December 01, 2022

What can affect the quality of carbide rolls?

What can affect the quality of carbide rolls? Tungsten carbide rolls have been used in all areas of metal plasticity processing. From non-ferrous metals to steel, from hot rolled wire rod and tube to...

Update December 01, 2022

Basic knowledge about crusher cutters

Basic knowledge about crusher cutters The clamping part of the crusher tool has two types with holes and with shanks. The crusher tool with holes relies on the bore set on the spindle or mandrel of...

Update October 08, 2020

mold components

What is mold components? Mold components refer to the general term for metal fittings used in stamping dies, plastic molds or FA automation equipment exclusively in the mould industry. The mold...

Update October 08, 2020

What is a mold?

What is a mold? With the rapid upgrading of digital products, the plastics industry has shown strong development momentum. The plastic mold processing industry has to go out, but how should the...

Update May 26, 2020

How to extend the life of stamping die

How to extend the life of stamping die The purpose of all stamping is: high productivity, high quality and low cost. The design and construction of the bed, top structure, and fuselage frame all play...

Update May 26, 2020

Commonly used grinding processing methods for mold parts

Commonly used grinding processing methods for mold parts 1. The general concept of grinding In mechanical processing, grinding is a finishing process. Grinding usually adopts manual operation, adding...

Update May 26, 2020

Process control of precision machining of mold parts

Process control of precision machining of mold parts For the processing of mold parts, the general guiding ideology is to adapt to different mold parts, different materials, different shapes and...

Update May 26, 2020

Hot runner plastic mold design procedure

Hot runner plastic mold design procedure First of all, according to the structure and use requirements of plastic parts, determine the position of the feed inlet. As long as the structure of the...