Page-3 Offer Ball Sleeve,Auto Mold Parts,Custom Wear Plate From China Manufacturer

China Components For Automobile Dies Suppliers

Die components

The main components for die In a hole toolsets are:

Die block – This is the main part that all the other parts are attached to.
Punch plate – This part holds and supports the different punches in place.
Blank punch – This part along with the blank die produces the blanked part.
Pierce punch – This part along with the pierce die removes parts from the blanked finished part.
Stripper plate – This is used to hold the material down on the blank/pierce die and strip the material off the punches.
Pilot – This will help to place the sheet accurately for the next stage of operation.
Guide, back gauge, or finger stop – These parts are all used to make sure that the material being worked on always goes in the same position, within the die, as the last one.
Setting (stop) block – This part is used to control the depth that the punch goes into the die.
Blanking dies in a hole – See blanking punch
Pierce die in a hole– See pierce punch.
Shank – used to hold in the presses. it should be aligned and situated at the center of gravity of the plate.
The most important component of the automobile mold is the cover mold. This type of die is mainly a cold die. "Automobile mold" in a broad sense is the general term for the molds used to make all the parts on the car. For example, stamping molds, injection molds, forging molds, casting wax molds, glass molds, etc.
The stamping parts on the car body are roughly divided into cover parts, beam parts and general stamping parts. The stampings that can clearly characterize the image of the car are car covers. Therefore, a more specific car mold can be said to be "a stamping mold for automobile cover parts". Referred to as the automobile cover die. For example, the trimming die for the outer panel of the front door, the punching die for the inner panel of the front door, etc.
Of course, not only the body of the car has stamping parts. The molds of all stamping parts on automobiles are called "auto stamping dies". The summary is:
1. Automobile mold is the general term for the molds that make all the parts on the car.
2. Auto stamping die is a die for stamping all stamping parts on the car.
3. The automobile body stamping die is a die for stamping all stamping parts on the automobile body.
4. The stamping die for automobile cover parts is a die for punching all the cover parts on the car body.